Easy Way Create Floating Candle Project

Easy Way Create Floating Candle Project

Posted by craft on

September 21, 2008

I assume that you’re already completing materials needs to create craft of floating candles. So, let’s doing this fun of candles project, step by step:

Prime your wick by dipping it into melted wax numerous times. This way use to keep the wick from absorbing water while the candles are floating. And so, cut off the set wick into match lengths, long enough for each candle, addition a little bit extra which will be accustomed gather below and protected the wick to the mold.

Put in a wick through the wick hole in each mold, and then fold the end of the wick over against the bottom of the mold and seal off the wick securely to the mold with mold seal. (In case the mold you’ve selected doesn’t have a wick hole, you’ll require creating one in the bottom to each one mold. This is normally only occur if you have bought a plastic mold.)

Heat the wax to 180^F. Add the Stearin and any color you desire. After the wax has melted, fill each mold to the top. It’s possible your wicks may fall to one side, but they can be straightened later.

Right away is a time to allow the molds cool. Either position them aside or wait for them to cool down or put them in a water tub. Even so, if you decide to use a water tub to quicken the setting process, be aware that the mold doesn’t tip and your paraffin wax lands up in the water tub. I personally don’t think passing any harder than it needs to be, so I just allow them sit right where they are until they have cooled down.

Once the surface is beginning to be set, but still soft, pull each wick upright. If you do this while the candle wax is still soft, it will give the wax a chance to settle and you’ll end up with a smoother result.

Allow the candles completely cool. Since the floating candles are small, there should be minimal sinking and you should not need to top them off. After they are set, remove the mold seal from the bottom of the mold. Straighten the wicks underneath and the candles will drop out of the mold easily.

With a sharp knife or craft blade, cut the underneath wick flush with the candle base.

Heat a pan lined with foil, press the base of each candle down onto the foil. This will melt the base slightly and seal the end of the wick. This is important, if your wick isn’t properly sealed; your candle will take on water and won’t burn.

While your candles finished, all you have to do is design your centerpiece. You may prefer to add flowers in a complimentary or contrasting color to the bowl. Occasionally I arrange large clear marbles in the bottom of the bowl, it just seems to give the centerpiece more depth. The marbles are viewable but don’t take away from the candles and daisies floating on top. Because floating candles tend to float low in the bowl, their flames are reflected up the glass bowl forming a really pretty centerpiece.